CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
Usage Information Using the following example of a static route: ip route 33.33.33.0 /24 tengigabitethernet 0/0 172.31.5.43
The software installs a next hop that is not on the directly connected subnet but which recursively resolves to
a next hop on the interface’s congured subnet. In the example, if gig 0/0 has an ip address on subnet 2.2.2.0
and if 172.31.5.43 recursively resolves to 2.2.2.0, Dell Networking OS installs the static route.
When the interface goes down, Dell Networking OS withdraws the route.
When the interface comes up, Dell Networking OS re-installs the route.
When recursive resolution is “broken,” Dell Networking OS withdraws the route.
When recursive resolution is satised, Dell Networking OS re-installs the route.
Related Commands show ip route — views the switch routing table.
ip source-route
Enable the system to forward IP packets with source route information in the header.
Syntax
ip source-route
To drop packets with source route information, use the no ip route-source command.
Defaults Enabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ip tcp initial-time
Dene the wait duration in seconds for the TCP connection to be established.
Syntax
ip tcp initial-time <8-75>
To restore the default behavior, which causes the wait period to be set as eight seconds, use the no ip tcp
initial-time command.
Parameters
<8-75> Wait duration in seconds for the TCP connection to be established.
Command Modes
CONFIGURATION
Supported Modes Full–Switch
IPv4 Routing 609