CLI Guide

If the line card is in a Jumbo mode chassis, you can also congure the mtu and ip mtu commands. The Link MTU
and IP MTU values congured on the channel members must be greater than the Link MTU and IP MTU values
congured on the Port Channel interface.
NOTE: In a Jumbo-enabled system, you must congure all members of a Port Channel with the same
link MTU values and the same IP MTU values.
Example
Dell(conf)#int port-channel 2
Dell(conf-if-po-2)#
Related Commands
interfacecongures a physical interface.
interface vlancongures a VLAN.
minimum-links
Congure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for the LAG to be also in “oper up” status.
Syntax
minimum-links number
Parameters
number Enter the number of links in a LAG that must be in “oper up” status. The range is from 1 to
16. The default is 1.
Defaults 1
Command Modes INTERFACE
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
If you use this command to congure the minimum number of links in a LAG that must be in “oper up” status, the
LAG must have at least that number of “oper up” links before it can be declared as up. For example, if the required
minimum is four, and only three are up, the LAG is considered down.
port-channel failover-group
To congure a LAG failover group, access PORT-CHANNEL FAILOVER-GROUP mode.
Syntax
port-channel failover-group
To remove all LAG failover groups, use the no port-channel failover-group command.
Interfaces 569