CLI Guide

Usage Information
The wavelength can be congured only on a tunable 10–Gigabit SFP+ optic. The wavelength range is from 1528.3
nm to 1568.77nm.
If you congure the wavelength on a non-tunable optic, there is no change to the existing wavelength. The
congured wavelength is saved in the running conguration and is applicable, when a tunable optic is used.
If you do not congure the wavelength on an inserted tunable optic, the existing wavelength is used.
Example
The following example shows the wavelength set for a tunable 10–Gigabit SFP+ optic:
Related Commands
• show cong — displays the interface conguration.
Port Channel Commands
A Link Aggregation Group (LAG) is a group of links that appear to a MAC client as if they were a single link according to IEEE 802.3ad. In
Dell Networking OS, a LAG is referred to as a Port Channel.
• For the Aggregator, the maximum port channel ID is 128 and the maximum members per port channel is 4.
Because each port can be assigned to only one Port Channel, and each Port Channel must have at least one port, some of those nominally
available Port Channels might have no function because they could have no members if there are not enough ports installed.
NOTE
: For information about Dell Networking OS link aggregation control protocol (LACP) for dynamic LAGs, refer to the Link
Aggregation Control Protocol (LACP) chapter. For more information about conguring and using Port Channels, refer to the Dell
PowerEdge FN I/O Aggregator Conguration Guide
channel-member
Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.
Syntax
channel-member interface
To delete an interface from a Port Channel, use the no channel-member interface command.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
Defaults Not congured.
Command Modes INTERFACE PORTCHANNEL
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
566 Interfaces