CLI Guide

mac {dest-mac |
source-dest-mac |
source-mac}
Enter the keywords to distribute MAC trac based on the following criteria:
dest-mac — Uses the destination MAC address, VLAN, Ethertype, source module ID
and source port ID elds to hash.
source-dest-mac — Uses the destination and source MAC address, VLAN,
Ethertype, source module ID and source port ID elds to hash.
source-mac — Uses the source MAC address, VLAN, Ethertype, source module ID and
source port ID elds to hash.
tcp-udp enable Enter the keywords to distribute trac based on the following:
enable — Takes the TCP/UDP source and destination ports into consideration when
doing hash computations. This option is enabled by default.
ingress-port enable—Enter the keywords to distribute trac based on the
following:
enable — Takes the source port into consideration when doing hash
computations. This option is disabled by default.
Defaults IP 4-tuple (IP SA, IP DA, Source Port, Destination Port)
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
By default, Dell Networking OS distributes incoming trac based on a hash algorithm using the following criteria:
• IP source address
• IP destination address
• TCP/UDP source port
• TCP/UDP destination port
load-balance hg
Choose the trac ow parameters the hash calculation uses while distributing the trac across internal higig links.
Syntax
[no] load-balance hg { ip-selection | ipv6-selection [source-ip | source-ipv6 |
source-port-id | source-module-id | dest-ip | dest-ipv6 | dest-port-id | dest-
module-id | protocol | vlan | L4-source-port | L4-dest-port ] | mac [source-mac
| source-port-id | source-module-id | dest-mac | dest-port-id | dest-module-id
| vlan | ethertype | source-dest-mac ] | tunnel [ipv4-over-ipv4 | ipv4-over-
gre-ipv4 | mac-in-mac]}
Parameters
ip-selection | ipv6-
selection [source-ip
| source-ipv6 |
source-port-id |
To use IPv4 key elds in hash computation, enter the keyword ip-selection then one of
the parameters. To use IPv6 key elds in hash computation, enter the keyword ipv6-
selection then one of the parameters.
• source-ip — Use IPv4 src-ip eld in hash calculation.
Interfaces 539