CLI Guide

interface range macro name
Run the interface-range macro to automatically congure the pre-dened range of interfaces.
Syntax
interface range macro name
Parameters
name Enter the name of an existing macro.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example (Single
Range)
This example shows the macro named test that was dened earlier.
Dell(config)#interface range macro test
Dell(config-if-range-te-0/0-3,te-5/0-8)#
Related Commands
interface range — congures a range of command (bulk conguration).
interface range macro (dene) — denes a macro for an interface range (bulk conguration).
interface vlan
Congure a VLAN. Congure the default VLAN to enable Static or DCHP IP conguration. You can congure up to 4094 VLANs.
Syntax
interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
Parameters
vlan-id Enter 1 for the default VLAN. Enter a number as the VLAN identier. The range is from 1
to 4096.
Defaults Not congured, except for the default VLAN, which is congured as VLAN 1.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
536 Interfaces