CLI Guide
dns-server
Assign a DNS server to clients based on address pool.
Syntax
dns-server address [address2...address8]
Parameters
address Enter a list of DNS servers that may service clients on the subnet. You may list up to eight
servers, in order of preference.
Defaults none
Command Modes DHCP <POOL>
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
domain-name
Assign a domain to clients based on the address pool.
Syntax
domain-name name
Parameters
name Give a name to the group of addresses in a pool.
Defaults none
Command Modes DHCP <POOL>
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
excluded-address
Prevent the server from leasing an address or range of addresses in the pool.
Syntax
excluded-address [address | low-address high-address]
Parameters
address Enter a single address to be excluded from the pool.
low-address Enter the lowest address in a range of addresses to be excluded from the pool.
high-address Enter the highest address in a range of addresses to be excluded from the pool.
Dynamic Host Conguration Protocol 437