CLI Guide
number Enter a weight for the queue on the shared buer as a number in the range of 1 to 11.
Default The default threshold weight on the shared buer for each queue is 9. Therefore, each queue can consume up to
66.67 percent of available shared buer by default.
Command Modes INTERFACE mode
Supported Modes Full–Switch
Usage Information You can congure all the data queues. You can congure queues 0-7. The following table describes the mapping
between the threshold weight of the shared buer on the queue. It also shows the percentage of the available
shared buer used by the queues for each of the corresponding threshold weights of the shared buer:
shared-
threshold-
weight on the
queue
% of available shared buer that can be consumed by the queue.
0 No dynamic sharing; shared buer = 0.
1 0.77%
2 1.54%
3 3.03%
4 5.88%
5 11.11%
6 20%
7 33.33%
8 50%
9 66.67%
10 80%
11 88.89%
Command History
Version Description
9.9(0.0) Introduced on the MXL.
Example
Dell(conf-if-te-1/8)#Service-class buffer shared-threshold-weight queue5 4
queue7 6
show stack-unit stack-ports pfc details
Displays the PFC conguration applied to ingress trac on stacked ports, including PFC Operational mode on each unit with the congured
priorities, link delay, and number of pause packets sent and received.
Syntax
show stack-unit {all | stack-unit} stack-ports {all | port-number} pfc details
Parameters
stack-unit Enter the stack unit.
port-number Enter the port number.
432 Data Center Bridging (DCB)