CLI Guide

show qos priority-groups
Displays the ETS priority groups congured on the switch, including the 802.1p priority classes and ID of each group.
Syntax
show qos priority-groups
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
NOTE: Please note that Dell Networking does not recommended to use this command as it has been
deprecated in the current 9.4(0.0) release. A warning message appears when you try to run this
command indicating that you have to use the dcb-map commands in the future.
Example
Dell#show qos priority-groups
priority-group ipc
priority-list 4
set-pgid 2
show qos dcb-map
Display the DCB parameters congured in a specied DCB map.
Syntax
show qos dcb-map map-name
Parameters
map-name Displays the PFC and ETS parameters congured in the specied map.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information
Use the show qos dcb-map command to display the enhanced transmission selection (ETS) and priority-based
ow control (PFC) parameters used to congure server-facing Ethernet ports.
The following table describes the show qos dcb-map output shown in the example below.
426 Data Center Bridging (DCB)