CLI Guide

Parameters
auto | cee | cin |
ieee-v2.5
Enter the DCBX version type used on the interface, where:
• auto: congures the port to operate using the DCBX version received from a peer.
• cee: congures the port to use CEE (Intel 1.01).
• cin: congures the port to use Cisco-Intel-Nuova (DCBX 1.0).
• ieee-v2.5: congures the port to use IEEE 802.1az (Draft 2.5).
Defaults Auto
Command Modes INTERFACE PROTOCOL LLDP
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Introduced on the FC Flex IO module installed in the M I/O Aggregator.
Usage Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Congure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the DCBX
conguration on a port, use the show interface dcbx detail command.
debug dcbx
Enable DCBX debugging.
Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail | mgmt | resource |
sem | tlv}
To disable DCBX debugging, use the no debug dcbx command.
Parameters
{all | auto-detect-
timer | cong-
exchng | fail | mgmt
| resource | sem |
tlv}
Enter the type of debugging, where:
• all: enables all DCBX debugging operations.
• auto-detect-timer: enables traces for DCBX auto-detect timers.
• config-exchng: enables traces for DCBX conguration exchanges.
• fail: enables traces for DCBX failures.
• mgmt: enables traces for DCBX management frames.
• resource: enables traces for DCBX system resource frames.
• sem: enables traces for the DCBX state machine.
• tlv: enables traces for DCBX TLVs.
Defaults none
Command Modes EXEC Privilege
Supported Modes Programmable-Mux (PMUX)
402 Data Center Bridging (DCB)