CLI Guide

vman-qos—dual—fp number] ipv4pbr number} ecfmacl number
[nlbclusteraclnumber]fcoeacl number iscsioptacl number}
Parameters
default Use the default CAM prole settings and set the CAM as follows:
• L3 ACL (ipv4acl): 4
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
• L2PT (L2PT): 0
• MAC ACL (IpMacAcl): 0
• VmanDualQos: 0
• EcfmAcl: 0
• nlbclusteracl: 0
• FcoeAcl: 4
• iscsiOptAcl: 2
l2acl number Enter the keyword l2acl and then the number of l2acl blocks. The range is from 1 to 8.
ipv4acl number Enter the keyword ipv4acl and then the number of FP blocks for IPv4. The range is
from 0 to 8.
ipv6acl number Enter the keyword ipv6acl and then the number of FP blocks for IPv6. The range is
from 0 to 4.
ipv4qos number Enter the keyword ipv4qos and then the number of FP blocks for IPv4. The range is
from 0 to 8.
l2qos number Enter the keyword l2qos and then the number of FP blocks for l2 qos. The range is from
1 to 8.
l2pt number Enter the keyword l2pt and then the number of FP blocks for l2 protocol tunnelling. The
range is from 0 to 1.
ipmacacl number Enter the keyword ipmacacl and then the number of FP blocks for IP and MAC ACL.
The range is from 0 to 6.
ecfmacl number Enter the keyword ecfmacacl and then the number of FP blocks for ECFM ACL. The
range is from 0 to 5.
nlbclusteracl
number
Enter the keyword nlbclusteracl and then the number of FP blocks for nlbcluster
ACL. The range is from 0 to 2. By default the value is 0 and it supports eight NLB arp
entries reserved for internal functionality.
NOTE: When you recongure CAM allocation, use the nlbclusteracl
number command to change the number of NLB ARP entries. The range is
from 0 to 2. The default value is 0. At the default value of 0, eight NLB ARP
entries are available for use. This platform supports upto 256 CAM entries.
Select 1 to congure 128 entries. Select 2 to congure 256 entries. Even
though you can perform CAM carving to allocate the maximum number of
NLB entries, Dell Networking recommends that you use a maximum of 64 NLB
ARP entries.
vman-qos|vman-
dual-qos number
Enter the keyword vman-qos and then the number of FP blocks for VMAN QoS. The
range is from 0 to 6.
Content Addressable Memory (CAM) 371