CLI Guide
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
If the set community rt and soo are in the same route-map entry, the behavior denes as:
• If the rt option comes before soo, with or without the additive option, soo overrides the communities rt
sets.
• If the rt option comes after soo, without the additive option, rt overrides the communities soo sets.
• If the rt with the additive option comes after soo, rt adds the communities soo sets.
Related Commands set extcommunity rt — sets the extended community route origins using the route-map.
show ip bgp paths extcommunity
To display all BGP paths having extended community attributes, use this feature.
Syntax
show ip bgp paths extcommunity
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The following describes the show ip bgp paths extcommunity command shown in the following example.
Field Description
Address Displays the internal address where the path attribute is stored.
Hash Displays the hash bucket where the path attribute is stored.
Refcount Displays the number of BGP routes using these extended communities.
Community Displays the extended community attributes in this BGP path.
Example
Dell#show ip bgp paths extcommunity
Total 1 Extended Communities
Address Hash Refcount Extended Community
0x41d57024 12272 1 RT:7:200 SoO:5:300 SoO:0.0.0.3:1285
Dell#
362 Border Gateway Protocol IPv4 (BGPv4)