CLI Guide

Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
timers bgp
Adjust the BGP Keep Alive and Hold Time timers.
Syntax
timers bgp keepalive holdtime
To return to the default, use the no timers bgp command.
Parameters
keepalive Enter a number for the time interval, in seconds, between keepalive messages sent to the
neighbor routers. The range is from 1 to 65535. The default is 60 seconds.
holdtime Enter a number for the time interval, in seconds, between the last keepalive message and
declaring the router dead. The range is from 3 to 65535. The default is 180 seconds.
Defaults none
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables multicast routing policy throughout the internet and connecting multicast
topologies between BGP and autonomous systems (ASs).
MBGP is implemented as per IETF RFC 1858.
debug ip bgp dampening
View information on routes being dampened.
Syntax
debug ip bgp ipv4 multicast dampening
To disable debugging, use the no debug ip bgp ipv4 multicast dampening command.
Parameters
dampening Enter the keyword dampening to clear route ap dampening information.
358 Border Gateway Protocol IPv4 (BGPv4)