CLI Guide

• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The following describes the show ip bgp flap command shown in the following example.
Field Description
Network Displays the network ID to which the route is apping.
From Displays the IP address of the neighbor advertising the apping route.
Flaps Displays the number of times the route apped.
Duration Displays the hours:minutes:seconds since the route rst apped.
Reuse Displays the hours:minutes:seconds until the apped route is available.
Path Lists all the ASs the apping route passed through to reach the destination network.
Example
Dell>show ip bgp flap-statistics
BGP table version is 210851, local router ID is 63.114.8.2
Status codes: s suppressed, d damped, h history, * valid, > best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network From Flaps Duration Reuse Path
Dell>
show ip bgp inconsistent-as
View routes with inconsistent originating autonomous system (AS) numbers; that is, prexes that are announced from the same neighbor
AS but with a dierent AS-Path.
Syntax
show ip bgp [ipv4 unicast] inconsistent-as
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The following describes the show ip bgp inconsistent-as command shown in the following example.
344 Border Gateway Protocol IPv4 (BGPv4)