CLI Guide

9.11.0.0 Introduced on the S-Series, Z-Series, MXL, and IOM.
Usage Information
You can use this command to disable all the congured BGP neighbors corresponding to the unicast IPv4 address
families.
This command is global for all VRFs.
shutdown address-family-ipv6–unicast
Disables all the BGP neighbors corresponding to the unicast IPv6 address families.
Syntax
shutdown address-family-ipv6–unicast
Use the no shutdown address-family-ipv6–unicast command to enable all the congured BGP
neighbors corresponding to the unicast IPv6 address families.
Command Modes
ROUTER BGP
CONFIGURATION
Command History
Version Description
9.11.0.0 Introduced on the S-Series, Z-Series, MXL, and IOM.
Usage Information
You can use this command to disable all the congured BGP neighbors corresponding to the unicast IPv6 address
families.
This command is global for all VRFs.
show capture bgp-pdu neighbor
Display BGP packet capture information for an IPv4 address on the system.
Syntax
show capture bgp-pdu neighbor ipv4-address
Parameters
ipv4-address Enter the IPv4 address (in dotted decimal format) of the BGP address to display packet
information for that address.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf-router_bgp)#show capture bgp-pdu neighbor 20.20.20.2
Incoming packet capture enabled for BGP neighbor 20.20.20.2
Available buffer size 40958758, 26 packet(s) captured using 680 bytes
332 Border Gateway Protocol IPv4 (BGPv4)