CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
With the Dell Networking OS version 8.3.1.0 and later, you can use the redistribute command to advertise the
IGP cost as the MED on redistributed routes. When you set the route-map with metric-type internal and apply
outbound to an EBGP peer/peer-group, the advertised routes corresponding to those peer/peer-groups have the
IGP cost set as MED.
When you enter the redistribute isis process-id command without any other parameters, the system
redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes. RFC does not support this
feature.
router bgp
To congure and enable BGP, enter ROUTER BGP mode.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number Enter the AS number. The range is from 1 to 65535 (2 byte), from 1 to 4294967295 (4
byte), or from 0.1 to 65535.65535 (dotted format).
Defaults Not enabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information At least one interface must be in Layer 3 mode for the router bgp command to be accepted. If no interfaces
are enabled for Layer 3, an error message appears:
% Error: No router id
configured
Example
Dell(conf)#router bgp 3
Dell(conf-router_bgp)#
shutdown all
Disables all the BGP neighbors.
Syntax
shutdown all
330 Border Gateway Protocol IPv4 (BGPv4)