CLI Guide

neighbor shutdown
Disable a BGP neighbor or peer group.
Syntax
neighbor {ip-address | peer-group-name} shutdown
To enable a disabled neighbor or peer group, use the neighbor {ip-address | peer-group-name} no
shutdown command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to disable or enable all routers within the peer group.
Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Peers that are enabled within a peer group are disabled when their peer group is disabled.
The neighbor shutdown command terminates all BGP sessions on the BGP neighbor or BGP peer group. Use
this command with caution as it terminates the specied BGP sessions. When a neighbor or peer group is shut
down, use the show ip bgp summary command to conrm its status.
Related Commands
show ip bgp summary — displays the current BGP conguration.
show ip bgp neighbors — displays the current BGP neighbors.
neighbor soft-reconguration inbound
Enable soft-reconguration for BGP.
Syntax
neighbor {ip-address | peer-group-name} soft-reconfiguration inbound
To disable, use the no neighbor {ip-address | peer-group-name} soft-reconfiguration
inbound command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to disable or enable all routers within the peer group.
Defaults Disabled
Command Modes ROUTER BGP
Supported Modes Full–Switch
324 Border Gateway Protocol IPv4 (BGPv4)