CLI Guide

Command Modes ROUTER BGP

Supported Modes Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

Applies to EBGP neighbors only.

Congure your system to accept 4-byte formats before entering a 4 byte AS Number.

If the AS-PATH contains both public and private AS number or contains AS numbers of an EBGP neighbor, the

private AS numbers are not removed.

If a confederation contains private AS numbers in its AS-PATH, the software removes the private AS numbers only

if they follow the confederation numbers in the AS path.

Private AS numbers are from 64512 to 65535 (2 byte).

neighbor route-map

Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.

Syntax

neighbor {ip-address | peer-group-name} route-map map-name {in | out}

To remove the route map, use the no neighbor {ip-address | peer-group-name} route-map

map-name {in | out} command.

Parameters

ip-address Enter the IP address of the neighbor in dotted decimal format.

peer-group-name Enter the name of the peer group.

map-name

Enter the name of an established route map.

If the Route map is not congured, the default is deny (to drop all routes).

in Enter the keyword in to lter inbound routes.

out Enter the keyword out to lter outbound routes.