CLI Guide

To disable debugging, use the no debug ip bgp [ip-address | peer-group peer-group-name]
notifications [in | out] command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group peer-
group-name
(OPTIONAL) Enter the keyword peer-group then the name of the peer group.
in (OPTIONAL) Enter the keyword in to view BGP notications received from neighbors.
out (OPTIONAL) Enter the keyword out to view BGP notications sent to neighbors
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To remove all congured debug commands for BGP, enter the no debug ip bgp command.
debug ip bgp soft-reconguration
Enable soft-reconguration debug.
Syntax
debug ip bgp {ip-address | peer-group-name} soft-reconfiguration
To disable, use the no debug ip bgp {ip-address | peer-group-name} soft-
reconfiguration command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name (OPTIONAL) Enter the name of the peer group to disable or enable all routers within the
peer group..
Defaults Disabled
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
This command turns on BGP soft-reconguration inbound debugging. If no neighbor is specied, debug turns on
for all neighbors.
Border Gateway Protocol IPv4 (BGPv4) 307