CLI Guide

show mac accounting access-list — displays MAC access list congurations and counters (if congured).
permit
To forward packets from a specic source MAC address, congure a lter.
Syntax
permit {any | mac-source-address [mac-source-address-mask]} [count [byte]] |
log [interval minutes] [threshold-in-msgs[count] [monitor]
To remove this lter, you have two choices:
• Use the no seq sequence-number command if you know the lter’s sequence number.
•
Use the no permit {any | mac-source-address mac-source-address-mask} command.
Parameters
any Enter the keyword any to forward all packets received with a MAC address.
mac-source-
address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask
(OPTIONAL) Specify which bits in the MAC address must match. If no mask is specied,
a mask of 00:00:00:00:00:00 is applied (in other words, the lter allows only MAC
addresses that match).
count (OPTIONAL) Enter the keyword count to count packets processed by the lter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the lter.
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny commands. The threshold
range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which ACL logs must be generated. The interval range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the trac that you
want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface
Defaults Not congured.
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added support for ow-based monitoring on the MXL 10/40GbE Switch IO Module
platform.
9.3(0.0) Added support for logging of ACLs on the MXL 10/40GbE Switch IO Module platform.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Access Control Lists (ACL) 185