CLI Guide

If ACL logging is stopped because the congured threshold is exceeded, it is re-enabled after the logging interval
period elapses. ACL logging is supported for standard and extended IPv4 ACLs, IPv6 ACLs, and MAC ACLs. You
can congure ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable logging for ACLs
that are associated with egress interfaces.
You can activate ow-based monitoring for a monitoring session by entering the flow-based enable
command in the Monitor Session mode. When you enable this capability, trac with particular ows that are
traversing through the ingress and egress interfaces are examined and, appropriate ACLs can be applied in both
the ingress and egress direction. Flow-based monitoring conserves bandwidth by monitoring only specied trac
instead all trac on the interface. This feature is particularly useful when looking for malicious trac. It is available
for Layer 2 and Layer 3 ingress and egress trac. You may specify trac using standard or extended access-lists.
This mechanism copies all incoming or outgoing packets on one port and forwards (mirrors) them to another port.
The source port is the monitored port (MD) and the destination port is the monitoring port (MG).
Related Commands
deny — congures a lter to drop packets.
permit — congures a lter to forward packets.
seq — assigns a sequence number to a deny or permit lter in an IP access list while creating the lter.
Extended IP ACL Commands
When an ACL is created without any rule and then applied to an interface, ACL behavior reects an implicit permit.
The following commands congure extended IP ACLs, which in addition to the IP address, also examine the packet’s protocol type.
The switch supports both Ingress and Egress IP ACLs.
NOTE
: Also refer to theCommands Common to all ACL Types and Common IP ACL Commands sections.
deny (for Extended IP ACLs)
Congure a lter that drops IP packets meeting the lter criteria.
Syntax
deny {ip | ip-protocol-number} {source mask | any | host ip-address}
{destination mask | any | host ip-address} [count [byte]] [dscp value] [order]
[monitor] [fragments] [log [interval minutes] [threshold-in-msgs [count]]
[monitor]
To remove this lter, you have two choices:
• Use the no seq sequence-number command if you know the lter’s sequence number.
• Use the no deny {ip | ip-protocol-number} {source mask | any | host ip-address}
{destination mask | any | host ip-address} command.
Parameters
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prex format (/x) or A.B.C.D. The mask, when specied in
A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the lter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
Access Control Lists (ACL) 159