CLI Guide

seq 10 Deny any
Dell(conf-std-nacl)#
Related Commands resequence access-list — Re-assigns sequence numbers to entries of an existing access-list.
resequence access-list
Re-assign sequence numbers to entries of an existing access-list.
Syntax
resequence access-list {ipv4 | mac} {access-list-name StartingSeqNum Step-to-
Increment}
Parameters
ipv4 | mac Enter the keyword ipv4 or mac to identify the access list type to resequence.
access-list-name Enter the name of a congured IP access list.
StartingSeqNum Enter the starting sequence number to resequence. The range is from 0 to 4294967290.
Step-to-Increment Enter the step to increment the sequence number. The range is from 1 to 4294967290.
Defaults none
Command Modes
EXEC
EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
When you have exhausted all the sequence numbers, this feature permits re-assigning a new sequence number to
entries of an existing access-list.
Related Commands resequence prex-list ipv4 — resequences a prex list.
resequence prex-list ipv4
Re-assign sequence numbers to entries of an existing prex list.
Syntax
resequence prefix-list ipv4 {prefix-list-name StartingSeqNum Step-to-increment}
Parameters
prex-list-name Enter the name of the congured prex list, up to 140 characters long.
StartingSeqNum Enter the starting sequence number to resequence. The range is from 0 to 65535.
Step-to-Increment Enter the step to increment the sequence number. The range is from 1 to 65535.
Defaults none
Command Modes
EXEC
150 Access Control Lists (ACL)