CLI Guide

fru dump Enter the keywords fru dump to display fru details.
stack-port 9-12 Enter the keywords stack-port and a stacking port number to select a stacking port
for which to display statistics. Identify the stack port number as you would to identify a
10G port that was in the same place in one of the rear modules.
NOTE: You can identify stack port numbers by physical inspection of the rear
modules. The numbering is the same as for the 10G ports. You can also
inspect the output of the show system stack-ports command.
unit 0-0 {counters |
details | ipmc-
replication | port-
stats [detail] |
register | table-
dump WORD}}
Enter the keyword unit then 0 for port-pipe 0, and then enter one of the following
keywords to troubleshoot errors on the selected port-pipe and to give status on why a
port is not coming up to register level: counters, details, ipmc-replication,
port-stats [detail], register, or table-dump WORD.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.8(0.0) Replaced the keyword port with interface.
9.4(0.0) Supported on the FN I/O Aggregator.
Example (data-
plane)
Dell#show hardware stack-unit 0 cpu data-plane statistics
bc pci driver statistics for device:
rxHandle :9798
noMhdr :0
noMbuf :0
noClus :0
recvd :9798
dropped :0
recvToNet :9778
rxError :0
rxDatapathErr :0
rxPkt(COS0) :0
rxPkt(COS1) :0
rxPkt(COS2) :25
rxPkt(COS3) :0
rxPkt(COS4) :0
rxPkt(COS5) :0
rxPkt(COS6) :0
rxPkt(COS7) :226
rxPkt(COS8) :9527
rxPkt(COS9) :0
rxPkt(COS10) :0
rxPkt(COS11) :20
rxPkt(UNIT0) :9798
transmitted :4353
txRequested :4353
noTxDesc :0
txError :0
txReqTooLarge :0
Debugging and Diagnostics
1385