CLI Guide
advertise-interval
Set the time interval between VRRP advertisements.
Syntax
advertise-interval {seconds | centisecs centisecs}
To return to the default settings, use the no advertise-interval command.
Parameters
seconds Enter a number of seconds. The range is from 1 to 255. The default is 1 second.
centisecs centisecs Enter the keyword centisecs followed by the number of centisecs in multiple of 25
centisecs. The range is 25 to 4075 centisecs in multiples of 25 centisecs.
Defaults 1 second or 100 centisecs
Command Modes INTERFACE-VRRP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.5(0.0) Introduced the support for centisecs on the MXL 10/40GbE Switch .
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Dell Networking OS recommends keeping the default setting for this command. If you do change the time interval
between VRRP advertisements on one router, change it on all routers.
authentication-type
Enable authentication of VRRP data exchanges.
Syntax
authentication-type simple [encryption-type] password
To delete an authentication type and password, use the no authentication-type command.
Parameters
simple Enter the keyword simple to specify simple authentication.
encryption-type (OPTIONAL) Enter one of the following numbers:
• 0 (zero) species an un-encrypted authentication data follows.
• 7 (seven) species a hidden authentication data follows.
password Enter a character string up to eight characters long as a password. If you do not enter an
encryption-type, the password is stored as clear text.
Defaults Not congured.
Command Modes VRRP
Supported Modes Full–Switch
Command History
Version Description
1344 Virtual Router Redundancy Protocol (VRRP)