CLI Guide
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
peer-routing-timeout
Congure the timeout for the software to wait before connecting to a VLT peer with a Down status. This command is applicable for both
IPV6/ IPV4.
Syntax
peer-routing-timeout value
To restore the default value, use the no peer-routing-timeout command.
Parameters
value Enter the timeout value in seconds. The range is from 1 to 65535. The default value is 0
(no timeout).
Command Modes VLT DOMAIN (conf-vlt-domain)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added the IPV6/IPV4 support on the MXL.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When the timer expires, the software checks to see if the VLT peer is now available. If the VLT peer is not available,
peer-routing is disabled on that peer.
primary-priority
Recongure the primary role of VLT peer switches.
Syntax
primary-priority value
Parameters
value To congure the primary role on a VLT peer, enter a lower value than the priority value of
the remote peer. The range is from 1 to 65535.
Default 32768
Command Modes VLT DOMAIN
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information After you congure the VLT domain on each peer switch on both sides of the interconnect trunk, by default, the
software elects a primary and secondary VLT peer device. To recongure the primary role of VLT peer switches,
use the priority command.
1332 Virtual Link Trunking (VLT)