CLI Guide

9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
peer-link port-channel
Congure the specied port channel as the chassis interconnect trunk between VLT peers in the domain.
Syntax
peer-link port-channel port-channel-number {peer-down-vlan vlan id}
Parameters
port-channel-
number
Enter the port-channel number that acts as the interconnect trunk.
peer-down-vlan
vlan id
Enter the keyword peer-down-vlan then a VLAN ID to congure the VLAN that the
VLT peer link uses when the VLT peer is down.
Defaults Not congured.
Command Modes VLT DOMAIN
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
Usage Information To congure the VLAN from where the VLT peer forwards packets received over the VLTi from an adjacent VLT
peer that is down, use the peer-down-vlan parameter. To ensure that the DHCP discover packets are forwarded
to the VLAN that has the DHCP server, use this conguration.
peer-routing
Enable L3 VLT peer-routing. This command is applicable for both IPV6/ IPV4.
Syntax
peer-routing
To disable L3 VLT peer-routing, use the no peer-routing command.
Defaults Disabled.
Command Modes VLT DOMAIN (conf-vlt-domain)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added the IPV6/IPV4 support on the MXL.
Virtual Link Trunking (VLT) 1331