CLI Guide

• show vlt role
• show vlt statistics
• stack-unit iom-mode
• system-mac
• unit-id
• vlt domain
• vlt-peer-lag port-channel
• show vlt private-vlan
back-up destination
Congure the IPv4 or IPv6 address of the management interface on the remote VLT peer to be used as the endpoint of the VLT backup
link for sending out-of-band hello messages.
Syntax
back-up destination {[ipv4–address] | [ipv6 ipv6–address] [interval seconds]}
Parameters
ipv4–address Enter the IPv4 address of the backup destination.
ipv6 Enter the keyword ipv6 then an IPv6 address in the X:X:X:X::X format.
interval seconds Enter the keyword interval to specify the time interval to send hello messages. The
range is from 1 to 5 seconds. The default is 1 second.
Defaults 1 second
Command Modes VLT DOMAIN
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree information base,
use the clear ip pim tib command.
Syntax
clear ip mroute {group-address [source-address] | * | snooping}
Parameters
group-address
[source-address]
Enter the multicast group address and source address (if desired), in dotted decimal
format, to clear information on a specic group.
* Enter * to clear all multicast routes.
snooping Enter the keyword snooping to delete multicast snooping route table entries.
Command Modes EXEC Privilege
Virtual Link Trunking (VLT) 1327