CLI Guide
Related Commands dei mark — sets the DEI value on egress.
vlan-stack access
Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not congured.
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Prior to enabling this command, to place the interface in Layer 2 mode, enter the switchport command.
To remove the access port designation, remove the port (using the no member interface command) from all
stackable VLAN enabled VLANs.
vlan-stack compatible
Enable the stackable VLAN feature on a VLAN.
Syntax
vlan-stack compatible
To disable the Stackable VLAN feature on a VLAN, use the no vlan-stack compatible command.
Defaults Not congured.
Command Modes CONF-IF-VLAN
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Prior to disabling the stackable VLAN feature, remove the members.
To view the stackable VLANs, use the show vlan command in EXEC Privilege mode. Stackable VLANs contain
members, designated by the M in the Q column of the command output.
Example
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
1322 VLAN Stacking