CLI Guide

To delete the conguration, use the no ntp source command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For Loopback interfaces, enter the keyword loopback then a number from zero (0)
to 16383.
• For a Port Channel interface, enter the keyword lag then a number. The range is
from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ntp trusted-key
Set a key to authenticate the system to which NTP synchronizes.
Syntax
ntp trusted-key number
To delete the key, use the no ntp trusted-key number command.
Parameters
number Enter a number as the trusted key ID. The range is from 1 to 4294967295.
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The number parameter in the ntp trusted-key command must be the same number as the number
parameter in the ntp authentication-key command. If you change the ntp authentication-key
command, you must also change the ntp trusted-key command.
Related Commands
ntp authentication-key — sets an authentication key for NTP.
ntp authenticate — enables the NTP authentication parameters you set.
1288 System Time