CLI Guide

packets Enter the keyword packets to display information on NTP packets.
select Enter the keyword select to display information on the NTP clock selection.
sync Enter the keyword sync to display information on the NTP clock synchronization.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ntp oset-threshold
Congure the threshold time interval before which the system generates an NTP audit log message if the time dierence from the NTP
server is greater than a threshold value (oset-threshold).
Syntax
ntp offset-threshold threshold-value
To disable the threshold value, use the no ntp offset-threshold command.
Parameters
oset-threshold
threshold-value
(Optional) Enter the keyword offset-threshold and then the threshold value. The
range is from 0 to 999.
Defaults Not enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3038–ON, S4048-ON, S3100 Series, S4810P, S4820T, S5000,
S6000, S6000–ON, S6100–ON, Z9500, and Z9100–ON.
Usage Information
The ntp offset-threshold command does not time synchronization.
Example
Dell(config)# ntp offset-threshold 4
ntp server
Congure an NTP time-serving host.
Syntax
ntp server {ipv4-address}
Parameters
ipv4-address Enter an IPv4 address (A.B.C.D).
Defaults Not congured.
1284 System Time