CLI Guide

• For Loopback interfaces, enter the keyword loopback then a number from zero (0)
to 16383.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a ten-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
•
For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Syslog messages contain the IP address of the interface used to egress the router. By conguring the logging
source-interface command, the Syslog packets contain the IP address of the interface congured.
Related Commands
logging — enables logging to the Syslog server.
logging synchronous
Synchronize unsolicited messages and output.
Syntax
logging synchronous [level level | all] [limit number-of-buffers]
To disable message synchronization, use the no logging synchronous [level level | all]
[limit number-of-buffers] command.
Parameters
all Enter the keyword all to ensure that all levels are printed asynchronously.
level level Enter the keyword level then a number as the severity level. A high number indicates a
low severity level and vice versa. The range is from 0 to 7. The default is 2.
all Enter the keyword all to turn o all.
limit number-of-
buers
Enter the keyword limit then the number of buers to be queued for the terminal after
which new messages are dropped. The range is from 20 to 300. The default is 20.
Defaults Disabled. If enabled without the level or number-of-buffers options specied, level = 2 and number-of-
buers = 20 are the defaults.
Command Modes LINE
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
1226 Simple Network Management Protocol (SNMP) and Syslog