CLI Guide
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
logging monitor — sets the logging monitor parameters.
terminal monitor — sends system messages to the terminal/monitor.
default logging trap
Return to the default settings for logging messages to the Syslog servers.
Syntax
default logging trap
Defaults level = 6 or informational
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands logging trap — limit messages logged to the Syslog servers based on severity.
logging
Congure an IP address or host name of a Syslog server where logging messages are sent. You can congure multiple logging servers of
both IPv4 and/or IPv6.
Syntax
logging {ip-address | ipv6–address |hostname} {{udp {port}} | {tcp {port}}
To disable logging, use the no logging command.
Parameters
ip-address Enter the IPv4 address in dotted decimal format.
ipv6-address Enter the IPv6 address in the x:x:x:x::X format.
NOTE: The :: notation species successive hexadecimal elds of zeros.
hostname Enter the name of a host already congured and recognized by the switch.
udp Enter the keyword udp to enable transmission of log message over UDP followed by port
number. The default port is 514
tcp Enter the keyword tcp to enable transmission of log message over TCP followed by port
number.
Defaults Disabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
1220 Simple Network Management Protocol (SNMP) and Syslog