CLI Guide

Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the MXL switch.
Example
Dell(conf)#sflow max-header-size extended
sow polling-interval (Global)
Set the sFlow polling interval at a global level.
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval command.
Parameters
interval value Enter the interval value in seconds. The range is from 15 to 86400 seconds. The default is
20 seconds.
Defaults 20 seconds
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The polling interval for an interface is the maximum number of seconds between successive samples of counters
sent to the collector. This command changes the global default counter polling (20 seconds) interval. You can
congure an interface to use a dierent polling interval.
sow polling-interval (Interface)
Set the sFlow polling interval at an interface (overrides the global-level setting).
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval command.
Parameters
interval value Enter the interval value in seconds. The range is from 15 to 86400 seconds. The default is
the global counter polling interval.
Defaults The same value as the current global default counter polling interval.
Command Modes INTERFACE
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
sFlow 1191