CLI Guide

The following table describes the show qos dcb-map output shown in the example below.
Field Description
State Complete: All mandatory DCB parameters are correctly congured. In progress: The DCB
map conguration is not complete. Some mandatory parameters are not congured.
PFC Mode PFC conguration in DCB map: On (enabled) or O.
PG Priority group congured in the DCB map.
TSA Transmission scheduling algorithm used by the priority group: Enhanced Transmission
Selection (ETS).
BW Percentage of bandwidth allocated to the priority group.
PFC PFC setting for the priority group: On (enabled) or O.
Priorities 802.1p priorities congured in the priority group.
Example
Dell# show qos dcb-map dcbmap2
State :Complete
PfcMode:ON
--------------------
PG:0 TSA:ETS BW:50 PFC:OFF
Priorities:0 1 2 4 5 6 7
PG:1 TSA:ETS BW:50 PFC:ON
Priorities:3
Related Commands
dcb-map — creates a DCB map to congure PFC and ETS parameters and applies the PFC and ETS settings on
Ethernet ports.
show qos policy-map
View the QoS policy map information.
Syntax
show qos policy-map {summary [interface] | detail [interface]}
Parameters
summary interface To view a policy map interface summary, enter the keyword summary and optionally one
of the following keywords and slot/port or number information:
• For a 10 Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
detail interface To view a policy map interface in detail, enter the keyword detail and optionally one of
the following keywords and slot/port or number information:
• For a 10 Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
Defaults none
Command Modes
• EXEC
Quality of Service (QoS) 1071