CLI Guide
• EXEC Privilege
Supported Modes Full—Swtich
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ip pim snooping interface commands shown in the following
example.
Field Description
Interface Displays the VLAN interfaces with PIM-SM snooping enabled.
Ver/Mode Displays the PIM version number for each VLAN interface with PIM-SM snooping
enabled:
• v2 = PIM version 2
• S = PIM Sparse mode
Nbr Count Displays the number of neighbors learned through PIM-SM snooping on the interface.
DR Prio Displays the Designated Router priority value congured on the interface (ip pim dr-
priority command).
DR Displays the IP address of the Designated Router for that interface.
Example (#2)
Dell#show ip pim snooping interface
Interface Ver Nbr DR DR
Count Prio
Vlan 2 v2 3 1 165.87.32.2
show ip pim snooping neighbor
Display information on PIM neighbors learned through PIM-SM snooping.
Syntax
show ip pim snooping neighbor [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to display information about PIM neighbors that PIM-SM
snooping discovered on a specied VLAN. The valid VLAN IDs range is from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full—Swtich
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
1004 PIM-Sparse Mode (PIM-SM)