Concept Guide

The session-id needs to be unique.
2 Congure the source ports or list of ports, ingress/egress trac to be monitored.
MONITOR SESSION mode
source {interface | range | any} destination remote—vlan vlan-id direction {rx | tx | both}
3 Activate a RPM session. no disable command is mandatory in order for a RPM session to be active.
MONITOR SESSION mode
no disable
4 (Optional) Enable ow-based monitoring on a ow by ow basis and also for VLAN as source.
MONITOR SESSION mode
flow-based enable
Conguring a destination session
Following are the steps for conguring a destination session on a switch.
You can congure the below steps on other destination switches to congure additional destination ports for this RPM session.
1 Congure the destination session for RPM.
CONFIGURATION mode
monitor session session-id
2 Associate the Layer 2 VLAN used to transport monitored trac with this destination session.
MONITOR SESSION mode
source remote-vlan vlan-id destination interface direction {rx | tx | both}
3 (Optional) Congure destination ports so that the VLAN tag is added to the monitored trac.
MONITOR SESSION mode
tagged destination interface
To congure destination ports as untagged ports, enter the untagged destinationcommand.
Port Monitoring
639