Concept Guide

range interface-range species one of
the following interface ranges:
tengigabitethernet slot/rst_port-
last_port
4 Repeat Steps 1 to 3 on other
destination switches to congure
additional destination ports for this
session
To delete one or more destination ports from a destination session, enter the no source remote-vlan vlan-id destination command.
To change the RPM VLAN used in the destination session, you must rst remove all destination ports. Then delete the current VLAN by
entering the no monitor session session-id source remote-vlan vlan-id command and re-enter the monitor session session-id source
remote-vlan command to congure the new VLAN ID.
To recongure destination ports as untagged ports, enter the untagged destination command.
Conguring a RSPAN VLAN for RPM
Following are the steps for conguring a RSPAN VLAN for RPM.
You must repeat the below mentioned steps on source, intermediate, and destination switches.
1 Enter global conguration mode.
EXEC mode
configure terminal
2 Create a VLAN to transport mirrored trac in RPM.
CONFIGURATION mode
interface vlan vlan-id
3 Congure the RSPAN VLAN to be used to transport mirrored trac in RPM.
VLAN INTERFACE mode
mode remote-port-mirroring
4 Congure a tagged port to carry mirrored trac in the VLAN.
VLAN INTERFACE mode
tagged interface
You can repeat this command to congure additional tagged ports for the VLAN.
Conguring a source session
Following are the steps for conguring a source session on a switch.
You can congure the below steps on other source switches to congure additional source ports for this RPM session.
1 Congure a new RPM session and specifying type as rpm dened a RPM session.
CONFIGURATION mode
monitor session session-id type rpm
638
Port Monitoring