Concept Guide

To change the RPM VLAN used in a source session, you can delete the session (no monitor session command) or remove the current
conguration by entering the no source interfaces destination remote-vlan vlan-id direction direction command. Then re-enter the
complete source command as described above to congure a new reserved VLAN for the same source ports in the session.
To delete one or more source VLANs from a mirroring session, enter the no source interfaces {vlan vlan-id | vlan range vlan-ids}
destination remote-vlan vlan-id direction direction command, specifying the source VLANs to be deleted, the source ports, remote VLAN
ID, and trac direction in the command syntax.
To update the source VLANs in a mirroring session, you must rst remove the RPM conguration by entering the complete no source
interfaces {vlan vlan-id | vlan range vlan-ids} destination remote-vlan vlan-id direction direction command. Then re-enter the command,
specifying the source VLANs, the source ports, remote VLAN ID, and trac direction in the command syntax.
Congure a Destination Session on Multiple Switches
Step Command Syntax Command Mode Task
1 monitor session session-id CONFIGURATION Congure the destination session for
remote port mirroring and enter
Monitor Session conguration mode.
2 source remote-vlan vlan-id
destination {single-interface | range
{interface-list | interface-range |
mixed-interface-list}}
MONITOR SESSION Associate the RPM VLAN used to
transport mirrored trac with this
destination session and congure the
destination ports to which an analyzer
is a connected.
Single-interface is one of the following
values:
tengigabitethernet slot/port
range interface-list species multiple
interfaces separated by a comma and
space: single-interface, single-
interface, single-interface.range
interface-range species one of the
following interface ranges:
tengigabitethernet slot/rst_port-
last_port
A space is required before and after
the dash (-).
range mixed-interface-list species
single interfaces and interface ranges
in any order: single-interface,
interface-range, single-interface
3
tagged destination {single-interface |
range interface-range}
MONITOR SESSION
(Optional) Congure destination ports
so that the reserved VLAN tag is
added to the monitored trac sent to
an analyzer.
Default: Destination ports send
untagged packets so that the
reserved VLAN ID is removed and the
original monitored packet is analyzed.
single-interface is one of the following
values:
tengigabitethernet slot/port
Port Monitoring 637