Concept Guide

CONFIGURATION mode
no router ospf process-id
• Reset the OSPFv2 process.
EXEC Privilege mode
clear ip ospf process-id
• View the current OSPFv2 status.
EXEC mode
show ip ospf process-id
Example of Viewing the Current OSPFv2 Status
Dell#show ip ospf 55555
Routing Process ospf 55555 with ID 10.10.10.10
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Number of area in this router is 0, normal 0 stub 0 nssa 0
Dell#
Assigning an OSPFv2 Area
After you enable OSPFv2, assign the interface to an OSPF area. Set up OSPF areas and enable OSPFv2 on an interface with the
network command.
You must have at least one AS area: Area 0. This is the backbone area. If your OSPF network contains more than one area, congure a
backbone area (Area ID 0.0.0.0). Any area besides Area 0 can have any number ID assigned to it.
The OSPFv2 process evaluates the network commands in the order they are congured. Assign the network address that is most explicit
rst to include all subnets of that address. For example, if you assign the network address 10.0.0.0 /8, you cannot assign the network
address 10.1.0.0 /16 because it is already included in the rst network address.
When conguring the network command, congure a network address and mask that is a superset of the IP subnet congured on the
Layer-3 interface for OSPFv2 to use.
You can assign the area in the following step by a number or with an IP interface address.
• Enable OSPFv2 on an interface and assign a network address range to a specic OSPF area.
CONFIG-ROUTER-OSPF-id mode
network ip-address mask area area-id
The IP Address Format is A.B.C.D/M.
The area ID range is from 0 to 65535 or A.B.C.D/M.
Enable OSPFv2 on Interfaces
Enable and congure OSPFv2 on each interface (congure for Layer 3 protocol), and not shutdown.
You can also assign OSPFv2 to a Loopback interface as a virtual interface.
OSPF functions and features, such as MD5 Authentication, Grace Period, Authentication Wait Time, are assigned on a per interface basis.
NOTE
: If using features like MD5 Authentication, ensure all the neighboring routers are also congured for MD5.
In the following example, an IP address is assigned to an interface and an OSPFv2 area is dened that includes the IP address of a Layer 3
interface.
576
Open Shortest Path First (OSPFv2 and OSPFv3)