Concept Guide

CLI Command Mode Prompt Access Command
• From every mode except EXEC and
EXEC Privilege, enter the exit
command.
NOTE: Access all of the following
modes from CONFIGURATION
mode.
10 Gigabit Ethernet Interface
Dell(conf-if-te-0/1)#
interface (INTERFACE modes)
Interface Range
Dell(conf-if-range)#
interface (INTERFACE modes)
Management Ethernet Interface
Dell(conf-if-ma-0/0)#
interface (INTERFACE modes)
MONITOR SESSION
Dell(conf-mon-sess)# monitor session
CONSOLE
Dell(config-line-console)#
line (LINE Modes)
VIRTUAL TERMINAL
Dell(config-line-vty)#
line (LINE Modes)
The following example shows how to change the command mode from CONFIGURATION mode to INTERFACE conguration mode.
Example of Changing Command Modes
Dell(conf)#interface tengigabitethernet 0/2
Dell(conf-if-te-0/2)#
The do Command
You can enter an EXEC mode command from any CONFIGURATION mode (CONFIGURATION, INTERFACE, and so on.) without having to
return to EXEC mode by preceding the EXEC mode command with the do command.
The following example shows the output of the do command.
Dell(conf)#do show system brief
Stack MAC : 00:1e:c9:de:03:7b
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
------------------------------------------------------------------------------------
0 Management online PE-FN-410S-IOA PE-FN-410S-IOA 1-0(0-1864) 12
1 Member not present
2 Member not present
3 Member not present
4 Member not present
5 Member not present
Dell#
Undoing Commands
When you enter a command, the command line is added to the running conguration le (running-cong).
To disable a command and remove it from the running-cong, enter the no command, then the original command. For example, to delete
an IP address congured on an interface, use the
no ip address ip-address command.
NOTE
: Use the help or ? command as described in Obtaining Help.
Example of Viewing Disabled Commands
Dell(conf)# interface managementethernet 0/0
Dell(conf-if-ma-0/0)# ip address 192.168.5.6/16
42
Conguration Fundamentals