Concept Guide
The DCBx conguration on the FCF-facing port is detected by the server-facing port and the DCB PFC conguration on both ports is
synchronized. For more information about how to congure DCBx and PFC on a port, refer to the Data Center Bridging (DCB) chapter.
The following example shows how to congure FIP snooping on FCoE VLAN 10, on an FCF-facing port (0/50), on an ENode server-facing
port (0/1), and to congure the FIP snooping ports as tagged members of the FCoE VLAN enabled for FIP snooping.
Example of Enabling the FIP Snooping Feature on the Switch (FIP Snooping Bridge)
Dell(conf)# feature fip-snooping
Example of Enabling FIP Snooping on the FCoE VLAN
Dell(conf)# interface vlan 10
Dell(conf-if-vl-10)# fip-snooping enable
Example of Enabling an FC-MAP Value on a VLAN
Dell(conf-if-vl-10)# fip-snooping fc-map 0xOEFC01
NOTE: Conguring an FC-MAP value is only required if you do not use the default FC-MAP value (0x0EFC00).
Example of Conguring the ENode Server-Facing Port
Dell(conf)# interface tengigabitethernet 0/1
Dell(conf-if-te-0/1)# portmode hybrid
Dell(conf-if-te-0/1)# switchport
NOTE: A port is enabled by default for bridge-ENode links.
Example of Conguring the FCF-Facing Port
Dell(conf)# interface tengigabitethernet 0/11
Dell(conf-if-te-0/11)# portmode hybrid
Dell(conf-if-te-0/11)# switchport
Dell(conf-if-te-0/11)# fip-snooping port-mode fcf
Example of Conguring FIP Snooping Ports as Tagged Members of the FCoE VLAN
Dell(conf)# interface vlan 10
Dell(conf-if-vl-10)# tagged tengigabitethernet 0/11
Dell(conf-if-te-0/11)# no shut
Dell(conf-if-vl-10)# no shut
After FIP packets are exchanged between the ENode and the switch, a FIP snooping session is established. ACLs are dynamically
generated for FIP snooping on the FIP snooping bridge/switch.
FCoE Transit
317