Concept Guide
• Disable next hop processing and congure the router as the next hop for a BGP neighbor.
CONFIG-ROUTER-BGP mode
neighbor {ip-address | peer-group-name} next-hop-self
• Sets the next hop address.
CONFIG-ROUTE-MAP mode
set next-hop ip-address
Changing the WEIGHT Attribute
To change how the WEIGHT attribute is used, enter the rst command. You can also use route maps to change this and other BGP
attributes. For example, you can include the second command in a route map to specify the next hop address.
• Assign a weight to the neighbor connection.
CONFIG-ROUTER-BGP mode
neighbor {ip-address | peer-group-name} weight weight
– weight: the range is from 0 to 65535.
The default is 0.
• Sets weight for the route.
CONFIG-ROUTE-MAP mode
set weight weight
– weight: the range is from 0 to 65535.
To view BGP conguration, use the show config command in CONFIGURATION ROUTER BGP mode or the show running-
config bgp command in EXEC Privilege mode.
Enabling Multipath
By default, the software allows one path to a destination. You can enable multipath to allow up to 16 parallel paths to a destination.
To allow more than one path, use the following command.
The show ip bgp network command includes multipath information for that network.
• Enable multiple parallel paths.
CONFIG-ROUTER-BGP mode
maximum-paths {ebgp | ibgp} number
The show ip bgp network command includes multipath information for that network.
Filtering BGP Routes
Filtering routes allows you to implement BGP policies.
You can use either IP prex lists, route maps, AS-PATH ACLs or IP community lists (using a route map) to control which routes the BGP
neighbor or peer group accepts and advertises. Prex lists lter routes based on route and prex length, while AS-Path ACLs lter routes
based on the ASN. Route maps can lter and set conditions, change attributes, and assign update policies.
NOTE
: The Dell Networking OS supports up to 255 characters in a set community statement inside a route map.
Border Gateway Protocol IPv4 (BGPv4) 209