Concept Guide

• If a packet's FO = 0, the next ACL entry is processed.
Deny ACL line with L3 information only, and the fragments keyword is present:
If a packet's L3 information does match the L3 information in the ACL line, the packet's FO is checked.
• If a packet's FO > 0, the packet is denied.
• If a packet's FO = 0, the next ACL line is processed.
Example of Layer 4 ACL Rules
Example of TCP Packets
In this rst example, fragments or non-fragmented TCP packets from 10.1.1.1 with TCP destination port equal to 24 are permitted. All other
fragments are denied.
Dell(conf)#ip access-list extended ABC
Dell(conf-ext-nacl)#permit tcp host 10.1.1.1 any eq 24
Dell(conf-ext-nacl)#deny ip any any fragment
Dell(conf-ext-nacl)
In the following example, TCP packets that are rst fragments or non-fragmented from host 10.1.1.1 with TCP destination port equal to 24
are permitted. Additionally, all TCP non-rst fragments from host 10.1.1.1 are permitted. All other IP packets that are non-rst fragments are
denied.
Dell(conf)#ip access-list extended ABC
Dell(conf-ext-nacl)#permit tcp host 10.1.1.1 any eq 24
Dell(conf-ext-nacl)#permit tcp host 10.1.1.1 any fragment
Dell(conf-ext-nacl)#
deny ip any any fragment
Dell(conf-ext-nacl)
Congure a Standard IP ACL
To congure an ACL, use commands in IP ACCESS LIST mode and INTERFACE mode.
For a complete list of all the commands related to IP ACLs, refer to the Dell Networking OS Command Line Interface Reference Guide. To
set up extended ACLs, refer to Congure an Extended IP ACL.
A standard IP ACL uses the source IP address as its match criterion.
1 Enter IP ACCESS LIST mode by naming a standard IP access list.
CONFIGURATION mode
ip access-list standard access-listname
2 Congure a drop or forward lter.
CONFIG-STD-NACL mode
seq sequence-number {deny | permit} {source [mask] | any | host ip-address} [count [byte]]
[order] [fragments]
NOTE
: When assigning sequence numbers to lters, keep in mind that you might need to insert a new lter. To prevent
reconguring multiple lters, assign sequence numbers in multiples of ve.
When you use the log keyword, the CP logs details about the packets that match. Depending on how many packets match the log entry
and at what rate, the CP may become busy as it has to log these packets’ details.
To view the rules of a particular ACL congured on a particular interface, use the show ip accounting access-list ACL-name
interface interface command in EXEC Privilege mode.
Example of Viewing the Rules of a Specic ACL on an Interface
Example of the seq Command to Order Filters
Dell#show ip accounting access-list ToOspf interface gig 1/6
Standard IP access list ToOspf
seq 5 deny any
116
Access Control Lists (ACLs)