CLI Guide

output interface For a multicast MAC address, enter the keyword output
then one of the following interfaces for which traffic is
forwarded:
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
output-range
interface
For a multicast MAC address, enter the keyword output-
range then one of the following interfaces to indicate a
range of ports for which traffic is forwarded:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
vlan vlan-id Enter the keyword vlan then a VLAN ID number from 1 to
4094.
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.3(0.0) Added support for multicast MAC address on the MXL
platform.
Example
(Multicast)
mac-address-table static 01:00:5E:01:00:01 {multicast vlan
2 output—range Te 0/2,Te 0/3}
ip vlan-flooding
Enable unicast data traffic flooding on VLAN member ports.
Syntax
ip vlan-flooding
To disable, use the no ip vlan-flooding command.
Command Modes CONFIGURATION
Supported Modes Full–Switch
994
Microsoft Network Load Balancing