CLI Guide

Example (Name)
Dellconf)#interface vlan 222
Dell(conf-if-vl-222)#name test
Dell(conf-if-vl-222)#do show vlan name test
Codes: * - Default VLAN, G - GVRP VLANs
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack
NUM Status Description Q Ports
222 Inactive U Gi 1/22
Dell(conf-if-vl-222)#
Related
Commands
vlan-stack compatible — enables the Stackable VLAN feature on the selected
VLAN.
interface vlan — configures a VLAN.
tagged
Add a Layer 2 interface to a VLAN as a tagged interface.
Syntax
tagged interface
To remove a tagged interface from a VLAN, use the no tagged interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Defaults All interfaces in Layer 2 mode are untagged.
Command Modes INTERFACE VLAN
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
When you use the no tagged command, the interface is automatically placed in
the Default VLAN as an untagged interface unless the interface is a member of
another VLAN. If the interface belongs to several VLANs, remove it from all VLANs
to change it to an untagged interface.
970
Layer 2