CLI Guide

Example
Dell-ct-mxl-1-b1(conf)#do show io-aggregator auto-lag status
Auto LAG creation on server port(s) is disabled
show lacp
Displays the LACP matrix.
Syntax
show lacp port-channel-number [sys-id | counters]
Parameters
port-channel-
number
Enter a port-channel number:
The range is from 1 to 128.
sys-id (OPTIONAL) Enter the keywords sys-id and the value that
identifies a system.
counters (OPTIONAL) Enter the keyword counters to display the
LACP counters.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Example (Port-
Channel-Number)
Dell#show lacp 128
Port-channel 1 admin up, oper up, mode lacp
Actor System ID:Priority 32768, Address 0001.e800.a12b
Partner System ID:Priority 32768, Address 0001.e801.45a5
Actor Admin Key 1, Oper Key 1, Partner Oper
Key 1
LACP LAG 1 is an aggregatable link
A-Active LACP, B-Passive LACP, C-Short Timeout, D-Long Timeout
E-Aggregatable Link, F-Individual Link, G-IN_SYNC, H-
OUT_OF_SYNC
I-Collection enabled, J-Collection disabled, K-Distribution
enabled L-Distribution disabled,
M-Partner Defaulted, N-Partner Non-defaulted, O-Receiver is in
expired state,
P-Receiver is not in expired state
Port Te 0/1 is enabled, LACP is enabled and mode is lacp
Actor Admin: State ACEHJLMP Key 1 Priority 128
Oper: State ACEGIKNP Key 1 Priority 128
950
Link Aggregation Control Protocol (LACP)