CLI Guide

Supported Modes
Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
Example
Dell(conf)#interface TenGigabitethernet 0/5
Dell(conf-if-te-0/5)#no shutdown
Dell(conf-if-te-0/5)#port-channel-protocol lacp
Dell(conf-if-te-0/5-lacp)#port-channel 32 mode active
...
Dell(conf)#interface TenGigabitethernet 0/6
Dell(conf-if-te-0/6)#no shutdown
Dell(conf-if-te-0/6)#port-channel-protocol lacp
Dell(conf-if-te-0/6-lacp)#port-channel 32 mode active
show interfaces port-channel
Display information on configured Port Channel groups.
Syntax
show interfaces port-channel [channel-number] [brief|
description]
Parameters
channel-number For a Port Channel interface, enter the keyword port-
channel followed by a number. The range is from 1 to 128.
brief (OPTIONAL) Enter the keyword brief to display only the
port channel number, the state of the port channel, and the
number of interfaces in the port channel.
description (OPTIONAL) Enter the keyword description to display
interface information with description.
NOTE: This command also enables you to view information corresponding to
a range of ports.
• For port-channel interfaces, you can specify multiple ports as port-
range
. For example, if you want to display information corresponding to
all ports between 1 and 4, specify the port range as show interfaces
port-channel 1 - 4.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
946
Link Aggregation Control Protocol (LACP)