CLI Guide

To disable the LACP link fallback member, use theno lacp link-fallback
member-independent port-channel 128 command.
Command Modes INTERFACE
Supported Modes
Standalone, Stacking
Full–Switch
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the M I/O Aggregator and FN I/O Aggregator.
lacp long-timeout
Configure a long timeout period (30 seconds) for an LACP session.
Syntax
lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the no lacp long-
timeout command.
Defaults 1 second
Command Modes INTERFACE (conf-if-po-number)
Supported Modes
Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command applies to dynamic port-channel interfaces only. When applied on a
static port-channel, this command has no effect.
Link Aggregation Control Protocol (LACP)
943