CLI Guide

dot1p vlan-
priority-value
Enter the dot1p value of the VLAN priority tag assigned to
the incoming packets in an iSCSI session. The range is from
0 to 7. The default is the dot1p value in ingress iSCSI frames
is not changed and is the same priority is used in iSCSI TLV
advertisements if you did not enter the iscsi priority-
bits command.
dscp dscp-value Enter the DSCP value assigned to the incoming packets in
an iSCSI session. The valid range is from 0 to 63. The default
is: the DSCP value in ingress packets is not changed.
remark Marks the incoming iSCSI packets with the configured dot1p
or DSCP value when they egress to the switch. The default
is: the dot1and DSCP values in egress packets are not
changed.
Defaults The default dot1p VLAN priority value is 4 without the remark option.
Command Modes CONFIGURATION
Supported Modes
Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
iscsi enable
Globally enable iSCSI optimization.
Syntax
iscsi enable
To disable iSCSI optimization, use the no iscsi enable command.
Parameters
enable Enter the keyword enable to enable the iSCSI optimization
feature.
Defaults Disabled.
Command Modes CONFIGURATION
iSCSI Optimization
877