CLI Guide

5
Control and Monitoring
This chapter describes control and monitoring for the I/O Aggregator.
asf-mode
Enable alternate store and forward (ASF) mode and forward packets as soon as a threshold is reached.
Syntax
asf-mode stack-unit {unit-id | all} queue size
To return to standard Store and Forward mode, use the no asf-mode stack
unit command.
Parameters
unit-id Enter the stack member unit identifier of the stack member
to reset. The range is from 0 to 5 or all.
queue size Enter the queue size of the stack member. The range is
from 0 to 5.
Defaults Not configured
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information You must save the configuration and reload the system to implement ASF. When
you enter the command, the system sends a message stating that the new mode is
enabled when the system reloads.
asset-tag
Assign and store a unique asset-tag to the stack member.
Syntax
asset-tag stack-unit unit id Asset-tag ID
Control and Monitoring
87