CLI Guide

debug ip bgp ipv6 unicast peer-group updates
View information about BGP peer-group updates.
Syntax
debug ip bgp ipv6 unicast peer-group peer-group-name updates
[in | out]
To disable debugging, use the no debug ip bgp ipv6 unicast peer-group
peer-group-name updates [in | out] command.
Parameters
peer-group peer-
group-name
Enter the keywords peer-group then the name of the
peer-group.
updates Enter the keyword updates to view BGP update
information.
in (OPTIONAL) Enter the keyword in to view only BGP
updates received from neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP
updates sent to neighbors.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
debug ip bgp ipv6 unicast updates
View information about BGP updates.
Syntax
debug ip bgp ipv6 unicast ipv6-address prefix-length updates
[in | out]
Parameters
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format then the prefix
length in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
updates Enter the keyword updates to view BGP update
information.
in (OPTIONAL) Enter the keyword in to view only BGP
updates received from neighbors.
852
IPv6 Border Gateway Protocol (IPv6 BGP)